Hikvision DS-2SE4C425MWG-E TandemVu PoE IP camera for video surveillance - 4MP resolution - Dual CMOS sensor (Bullet: 1/3 "/ PTZ: 12.8") and dual 2.8mm lens for Bullet and 4.8-120mm for PTZ - 25x optical zoom - Alarm - Audio - Triple Stream - Codec H.265 + - DayNight (ICR) - WDR 120dB - AWB - BLC - HLC - 3DNR - EIS - Defog - ROI - Slot for MicroSD 256GB - IP66 and TVS 6000 protection against lightning - 100M Ethernet LAN.
€1,207.74
€1,858.06 -35%DS-2SE4C425MWG-E | HIKVISION IP POE 4 MP CAMERA - DOUBLE LENS BULLET 2.8MM and PTZ 4.8-120MM PTZ ZOOM "% X - AUDIO - ALARM - DUAL IR
TandemVu PoE IP Camera - Hikvision DS-2SE4C425MWG-E
| ||
POE (Power Over Ethernet): The advantage of a PoE camera is obvious, it allows it to be powered with the same cable with which it communicates without bringing additional power cables and without having to install a separate power supply system, a PoE camera guarantees constant voltages and simple installation. | ||
Resolution: Resolution: 2560 × 1440. | ||
Double Optic: This camera has dual optics: PTZ camera : 4.8mm-120mm 25x optical zoom | ||
Optics: This camera features 2.8mm fixed lens | ||
Compression H.265 +
A self-developed intelligent algorithm by Hikvision that can greatly reduce the video bitrate based on a standard H.265 codec. Hikvision's H.265 + reduces transmission bandwidth and required storage capacity without impacting video quality, thanks to three key technologies: prediction encoding, noise suppression and flexible bit rate control. Optimized for multiple surveillance scenarios, it allows for greater use of ultra HD surveillance cameras, such as 8MP and 12MP cameras. | ||
IR Infrared Illuminator: White light illumination up to 30m. | ||
HIK-CONNECT Hik Connect allows you to control the device remotely | ||
WDR 120dB (Wide Dynamic Range): WDR (Wide Dynamic Range): It is the professional solution in cases where it is necessary to operate in conditions of high light / shadow contrast. Fundamental in the case of shots from the inside out, license plates, shaded spots or all situations where there is no homogeneity of light. The higher the db value, the greater the ability of the camera to manage the strong difference in the backlight present. Common WDRs usually reach 80db, the human eye is able to recognize a difference of up to 100db. This model reaches up to 120db managing very strong contrast levels. | ||
ROI (Region Of Interest): The images deriving from IP cameras are “compressed”, consequently the quality is set during the recording phase. Especially on cameras with a very high resolution, it is often necessary to reduce the quality in order to guarantee a reduced bandwidth occupation and record a greater number of days or cameras. The ROI allows you to define areas where you can set a higher quality (for example a door, the area where the plate usually passes, an exit, etc.). In that area I can set a higher quality thus guaranteeing a greater definition of the image. | ||
Day / Night: Allows you to adapt the lens to night / day vision, and the relative automatic management of the IR illuminator, when present. | ||
IR CUT FILTER (ICR): Mechanical filter that allows a correct display of images in daytime viewing conditions. It filters the typical infrared frequencies thus improving the image quality. In night conditions the filter is removed as it is necessary to capture the typical IR frequencies. | ||
BLC (Back Light Compensation): is one of the 3 possible steps in the management of images with contrast, typical situations are (entrances or exits from car parks, plates, special lights, entrances with shots from inside to outside, etc.) light compensation is one of the most complex possible, the BLC function allows a fair adaptation to these situations | ||
AGC (Automatic Gain Control): integrated signal amplifier that allows viewing even in critical conditions. It is automatic and does not require specific settings. | ||
3D- DNR: | ||
Interface | ||
Communication Interface | RJ45, self-adaptive 10M / 100M Ethernet port | |
On-board Storage | Built-in memory card slot, support Micro SD / Micro SDHC / Micro SDXC, up to 256GB | |
Alarm Input | 1 alarm input | |
Alarm Output | 1 alarm output | |
Audio Input | 1 audio input, 2.0 to 2.4Vp-p, 1k Ohm ± 10% | |
Audio Output | 1 audio output, line level, impedance: 600 Ω | |
Event | ||
Basic Event | motion detection, video tampering alarm, alarm input and output, exception | |
Smart Event | audio exception detection, line crossing detection, intrusion detection, region entrance detection, region exiting detection | |
Alarm Linkage | [Bullet channel] Upload to FTP / NAS / memory card, notify surveillance center, send email, trigger alarm output, and trigger recording [PTZ channel] Upload to FTP / NAS / memory card, notify surveillance center, send email, trigger alarm output, trigger recording, and PTZ actions (such as preset, patrol scan, pattern scan) | |
Deep Learning Function | ||
Face Capture | [Bullet channel] no, [PTZ channel] yes | |
General | ||
General Function | mirror, password protection, watermark, IP address filter | |
Power | 12VDC, PoE + | |
Power Consumption and Current | Max. 24 W, including max. 2.6 W for heater and max. 11 W for supplement light | |
Operating Conditions | -30? to 65? (-22 ° F to 149 ° F), humidity lower than 90% RH | |
Reset | yes | |
Demist | Demist by heating the glass | |
Material | ADC12 | |
Dimensions | Ø 166 mm × 375 mm (Ø 6.5 "× 14.7") | |
Weight | Approx. 2.4 kg (13.2 lb.) |
Approval | |
Protection | IP66 Standard, 6000 V Lightning Protection, Surge Protection and Voltage Transient Protection |
Further details
Download
OTHER PRODUCTS RELATED TO THIS ITEM
Questions (0)
No customer questions for the moment.