DS-2CD2446G2-I (2.8mm) Hikvision camera - IP PoE Cube - 4MP resolution 2688x1520 - 2.8mm fixed lens - 1/3 "CMOS sensor, PIR sensor with range up to 8m - IR 10m - Codec H.265 + . Day & Night (ICR), Triple Stream, ROI, WDR 120dB, BLC, 3D DNR, AGC, Motion Detection, Video Tamper Tamper - Hik-Connect - Reset button - Microphone - Two-way audio - Video Analysis: perimeter protection and face detection - Slot for MicroSD up to 256GB (not included) - Made of plastic.
€246.62
€379.42 -35%DS-2CD2446G2-I (2.8mm) | HIKVISION IP POE 4MP CAMERA - 2.8MM - PIR - MICROPHONE - IR 10M - H.265 +
Hikvision IP PoE Cube camera with 2.8mm 4MP lens
Resolution: 4MP - 2.8mm fixed lens - 1/3 "CMOS sensor - H.265 +
PIR sensor with detection up to 8m - IR up to 10m - Day / Night (ICR) - WDR 120dB - AGC -BLC - HLC - 3D DNR - Motion Detection - Triple Stream - Microphone - Two-way audio - Video Analysis with face detection and perimeter protection - Power supply NOT included - 24 month warranty
POE (Power Over Ethernet): The advantage of a PoE camera is obvious, it allows it to be powered with the same cable with which it communicates without carrying additional power cables and without having to install a separate power supply system, a PoE camera guarantees constant voltages and simple installation. |
Resolution: This camera features a resolution of 4MP 4 Megapixel 1/3 ”4Megapixel progressive scan CMOS image sensor of 4MP 2688x1520 |
Optics: This camera features 2.8mm fixed lens |
Compression H.265 +
A self-developed intelligent algorithm by Hikvision that can greatly reduce the video bitrate based on a standard H.265 codec. Hikvision's H.265 + reduces transmission bandwidth and required storage capacity without impacting video quality, thanks to three key technologies: prediction encoding, noise suppression and flexible bit rate control. Optimized for multiple surveillance scenarios, it allows for greater use of ultra HD surveillance cameras, such as 8MP and 12MP cameras. |
PIR: |
Lighting: Equipped with IR illuminator up to 10m. |
HIK-CONNECT Hik Connect allows you to control the device remotely |
ROI (Region Of Interest): The images deriving from IP cameras are “compressed”, consequently the quality is set during the recording phase. Especially on cameras with a very high resolution, it is often necessary to reduce the quality in order to guarantee a reduced bandwidth occupation and record a greater number of days or cameras. The ROI allows you to define areas where you can set a higher quality (for example a door, the area where the plate usually passes, an exit, etc.). In that area I can set a higher quality thus guaranteeing a greater definition of the image. |
Day / Night: Allows you to adapt the lens to night / day vision, and the relative automatic management of the IR illuminator, when present. |
IR CUT FILTER (ICR): Mechanical filter that allows correct viewing of images in daytime viewing conditions. It filters the typical infrared frequencies thus improving the image quality. In night conditions the filter is removed as it is necessary to capture the typical IR frequencies. |
BLC (Back Light Compensation): is one of the 3 possible steps in the management of images with contrast, typical situations are (entrances or exits from car parks, plates, special lights, entrances with shots from inside to outside, etc.) light compensation is one of the most complex possible, the BLC function allows a fair adaptation to these situations |
AGC (Automatic Gain Control): integrated signal amplifier that allows viewing even in critical conditions. It is automatic and does not require specific settings. |
WDR 120dB |
3D- DNR: |
Diet: A 12V DC power supply is required for the operation of this camera (not included) |
MicroSD slot The memory card IS NOT INCLUDED |
Data sheet
DS-2CD2446G2-I (2.8mm) |
Day, Night, Auto, Schedule
Image Enhancement
BLC, HLC, 3D DNR
Image Parameters Switch
Yes
Image Settings
Rotate, mirror, privacy mask, saturation, brightness, contrast, sharpness, gain, white balance adjustable by client software or web browser
PIR
PIR Angle
Horizontal: 90 °, vertical: 80 °
PIR Range
Up to 8 m
Interface
Built-in Microphone
Yes
Built-in Speaker
Power: 1 W. Max. Sound pressure level: 10 cm: 91 dB.
On-board Storage
Built-in memory card slot, support microSD / SDHC / SDXC card, up to 256GB
Hardware Reset
Yes
Communication Interface
1 RJ45 10M / 100M self-adaptive Ethernet port
Event
Basic Event
Motion detection, video tampering alarm, exception
Smart Event
Scene change detection
Linkage
Upload to FTP / memory card / NAS, notify surveillance center, trigger recording, trigger capture, send email, audible warning
Deep Learning Function
Face Capture
Yes
Perimeter Protection
Line crossing, intrusion, region entrance, region exiting Support alarm triggering by specified target types (human and vehicle)
General
Power
12 VDC ± 25%, 0.5 A, max. 6.0 W, Ø 5.5 mm coaxial power plug PoE: (802.3af, Class 3, 36 V to 57 V), 0.2 A to 0.13 A, max. 7.0 W
Web Client Language | 33 languages English, Russian, Estonian, Bulgarian, Hungarian, Greek, German, Italian, Czech, Slovak, French, Polish, Dutch, Portuguese, Spanish, Romanian, Danish, Swedish, Norwegian, Finnish, Croatian, Slovenian, Serbian, Turkish, Korean, Traditional Chinese, Thai, Vietnamese, Japanese, Latvian, Lithuanian, Portuguese (Brazil), Ukrainian |
General Function | Anti-flicker, heartbeat, password reset via email, pixel counter |
Storage Conditions | -10 ° C to 40 ° C (14 ° F to 104 ° F). Humidity 95% or less (non-condensing) |
Startup and Operating Conditions | -10 ° C to 40 ° C (14 ° F to 104 ° F). Humidity 95% or less (non-condensing) |
Camera Material | Plastic |
Dimension room | 102.9 mm × 65.2 mm × 32.6 mm (4.1 "× 2.6" × 1.3 ") |
Package Dimension | 150mm × 125mm × 99mm (5.9 "× 4.9" × 3.9 ") |
Camera Weight | Approx. 120 g (0.3 lb.) |
With Package Weight | Approx. 430 g (0.9 lb.) |
Approval | |
EMC | FCC SDoC (47 CFR Part 15, Subpart B); CE-EMC (EN 55032: 2015, EN 61000-3-2: 2019, EN 61000-3-3: 2013 + A1: 2019, EN 50130-4: 2011 + A1: 2014); KC (KN 32: 2015, KN 35: 2015) |
Safety | UL (UL 62368-1); CB (IEC 62368-1: 2014 + A11); CE-LVD (EN 62368-1: 2014 / A11: 2017) |
Environment | CE-RoHS (2011/65 / EU); WEEE (2012/19 / EU); Reach (Regulation (EC) No 1907/2006) |
Further details
Download
OTHER PRODUCTS RELATED TO THIS ITEM
Questions (0)
No customer questions for the moment.